Dell S100, S300 manual DVD, and so on, perform the following

Table 5-2. Pre-Installation Procedures For The Controller Drivers (continued)

Procedure	Steps
6 Change the Boot	To change the order of the devices (CD-ROM, optical
Priority List	DVD, and so on), perform the following:
for Devices (if	NOTE: Unless mentioned otherwise, the term PERC Virtual
applicable)	Disk Management utility refers to both the PERC S100 Virtual
	Disk Management utility and the PERC S300 Virtual Disk
	Management utility.
	NOTE: If the PERC Virtual Disk Management utility is open,
	select Continue to Boot, then press <Enter>. Press
	<Ctrl><Alt><Delete> to reboot the system.
	a Boot the system. When the POST screen appears,
	press <F2>.
	b At the Dell PowerEdge System screen, use the arrow
	keys to scroll to Boot Sequence. Press <Enter>.
	c Make sure that Hard drive C: is the first device
	listed.
	d To change the sequence of other devices:
	•Use the <+> key to move devices up, or the <-> key
	to move devices down.

•Use the space bar to enable or disable a device.

ePress <Esc> to exit.

fPress <Esc> again. Select Save Changes and Exit and press <Enter>.

NOTE: Continue with one of the following procedures:

•"Installing the Controller Drivers During the Operating System Installation: For Systems with a PERC S100 Adapter" on page 42

•"Installing the Controller Drivers During the Operating System Installation: For Systems with a PERC S300 Adapter" on page 44

Installing the Drivers

41