Dell S100, S300 manual From virtual disk creation

Table 7-7. Other Errors Appearing on the BIOS

Issue Likely Causes to Check Corrective Actions

The RAID 0 goes	Faulty physical disk
offline and the RAID 1
becomes degraded in a
PowerEdge R210
system with two drives.

1 Boot system into CTLR-R and replace faulty drive.

2 Delete the failed RAID 0 and then create a new RAID 0. Now RAID 0 is optimal and RAID 1 is still degraded.

3 Install OS on the RAID 0 and backup RAID 1.

4 Delete and Recreate RAID 1 and restore backup data.

When attempting to	DUPs are not	Use the DOS utilities
update system	supported.
backplane firmware
and or Hard drive
firmware using DUPs
the updates fail.
eSata devices appear in	Issue with the physical	Remove the devices from eSata port
Ready state in CTLR-R	connection	and plug them into the chassis.
		NOTE: eSATA devices are blocked
		from virtual disk creation.
During CTRL-R,	The function is not	Remove all physical disks except for
S100/S300 do not	supported.	the last one(s) added. Then proceed
display greater than		with deleting the virtual disks that
eight Virtual Disks.		are not needed. Remember to take
		account of the virtual disks that are
		currently being used.
Unable to delete	The function is not	Remove all physical disks except for
Virtual Disks when	supported.	the last one(s) added. Then proceed
there are more than		with deleting the virtual disks that
eight Virtual Disks		are not needed. Remember to take
present in the system.		account of the virtual disks that are
		currently being used.
Virtual disk rebuild	Rebuild is not	Boot to a supported OS. Rebuild
status while during	supported in Ctrl-R.	starts. To view rebuild status, install
CTLR-R		a supported storage application.

Troubleshooting

69