Dell 200, 6100 manual Figure B-1 Column x 25-Line Character Set Subtest Screen

Figure 7-7.	Power Supply Features	. 7-9
Figure 7-8.	Removing the Power Supply	7-10
Figure 7-9.	Replacing a Cooling Fan	7-11
Figure 8-1.	System Board Features	. 8-2
Figure 8-2.	Expansion Cards	. 8-3
Figure 8-3.	Expansion-Card Connectors on the System Board	. 8-3
Figure 8-4.	Memory Module and SIMM Sockets	. 8-5
Figure 8-5.	Installing a SIMM	. 8-9
Figure 8-6.	Removing a SIMM	. 8-9
Figure 8-7.	Microprocessor Module	. 8-9
Figure 8-8.	Microprocessor Securing Clip	8-12
Figure 8-9.	Removing the Microprocessor	8-12
Figure 8-10.	Pin-1 Identification	8-13
Figure 8-11.	Installing the Microprocessor	8-13
Figure 8-12.	Installing the Heat Sink	8-14
Figure 8-13.	RTC Chip	8-15
Figure 9-1.	External Drive Bay Hardware	. 9-2
Figure 9-2.	Removing a Front-Panel Insert	. 9-3
Figure 9-3.	Power Connectors	. 9-3
Figure 9-4.	Header Connector	. 9-3
Figure 9-5.	DC Power Cable Connectors	. 9-4
Figure 9-6.	Attaching Drive Rails	. 9-5
Figure 9-7.	Cable Connections for a SCSI Device in the
	External Drive Bays	. 9-6
Figure 10-1.	Internal Drive Hardware	10-2
Figure 10-2.	Installing a SCSI Hard-Disk Drive Carrier	10-3
Figure 10-3.	Cable Configuration for a PowerEdge Expandable
	RAID Controller Host Adapter Card	10-5
Figure 10-4.	Daisy-Chaining External SCSI Devices	10-6
Figure B-1.	80-Column x 25-Line Character Set Subtest Screen	. B-2
Figure B-2.	40-Column x 25-Line Character Set Subtest Screen	. B-2
Figure B-3.	640 x 480 Monochrome Graphics Mode Screen	. B-4
Figure B-4.	640 x 480 2-Color Graphics Mode Screen	. B-5
Figure C-1.	System Board Jumpers and Switches	. C-2
Figure C-2.	Microprocessor Module Jumpers	. C-6
Figure C-3.	SCSI Backplane Board	. C-8
Figure C-4.	Power-Supply Paralleling Board	. C-9

xviii