Dell 6100, 200 manual Removing SIMMs

pin 1

Figure 8-5. Installing a SIMM

4.Continue with step 7 of “Performing a Memory Upgrade” earlier in this section.

Removing SIMMs

To remove a SIMM, start from the highest-numbered socket, open the retaining clips just enough to lift the top edge of the SIMM away from the clips, and lift the SIMM out of the socket (see Figure 8-6).

pin 1

2.

1.

Figure 8-6. Removing a SIMM

Upgrading the Microprocessor or Installing Additional Microprocessors

The system board has two microprocessor module con- nectors. Each microprocessor module can have one or two Intel® Pentium® Pro microprocessors installed for a total of four microprocessors (see Figure 8-7). All micro- processors on both modules must be identical. For example, if the system has a 200 megahertz (MHz) Pentium Pro microprocessor and you are adding micro- processors, all additional microprocessors must also be 200 MHz Pentium Pro.

Figure 8-7. Microprocessor Module

Installing System Board Options 8-9