CBM-270 User’s Manual
2.3 Paper Specifications
2.3.1 | Recommended Paper |
|
(1) | Thermal paper roll |
|
| ∙Type | : Thermal paper |
| ∙Paper width | : 58 + 0/- 1 mm |
| ∙Paper thickness | : 60∼75μm |
| ∙Roll diameter | : φ83 mm or less |
| ∙Printing surface | : Outside of the roll (Surface) |
| ∙Recommended paper | : |
|
| |
| ||
| ∙Core | :φ12 mm(Inner dia.), φ18 mm (Outer dia.) |
(2) Thermal label paper(L and M spec. only) | ||
| ∙Type | : Thermal paper (Printing surface) |
| ∙Paper width | : 58 + 0/- 1 mm |
| ∙Label width | : 56 mm or less |
| ∙Label length | : 25∼300 mm (For label interval detection) |
| 25∼300 mm (For black mark detection) ∗ Black mark section excluded | |
| ∙Label interval | : 3∼300 mm (Black mark interval for the black mark detection) |
| ∙Black mark width | : 15 mm or more (From the center of the paper, black paper only) |
| ∙Paper thickness | : 150μm or less |
| ∙Roll diameter | : φ83 mm or less (Depends on the outer diameter of the core) |
| ∙Printing surface | : Outside of the roll (Surface) |
| ∙Recommended paper | : For label interval detection |
|
| KPT86S P22 G63BC (Monochrome) made by OHJI TUCK or |
| its equivalent |
|
|
| For black mark detection |
|
| KPT865P (Monochrome) made by OHJI TUCK or its equivalent |
| ∙Core | : φ12 mm or more (Inner dia.), 3 mm thick |
CAUTION:
1.Use of
2.Do not paste the paper to the core.
3.If the paper comes in contact with a chemical or oil, it may discolor or lose a record.
4.Do not rub the paper surface strongly with a nail or hard metal. It may discolor.
5.Discoloring starts at about 70°C. Watch out for effects of heat, humidity, light, and so on.
6.Do not use the label paper when the printer has been set for thermal paper, and vice versa. Be careful not to mistake a type of label paper. It could cause malfunctioning or damage the printing head.
2.3.2Printing Position
(1)Thermal paper