Citizen Systems CBM-270 user manual GS C2 n1 n2, GS C N1 N2 N3 N4 N5

			CBM-270 User’s Manual
GS C2 n1 n2
[Function]	Setting the numbering counter
[Code]	<1D>H<43>H<3B>H<N1><3B>H<N2><3B>H<N3><3B>H<N4><3B>H
	<N5><3B>H
	<1D>H<43>H<32>H<n1><n2>
[Range]	0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
[Outline]	This command sets the numbering (serial number counter) value.
	n1 + n2 × 256 (n1 = remainder, n2 = quotient) becomes a counter value.
[Caution]	If the counter is set with this command, a repeat count of the identical counter will be
	cleared. If the counter value is beyond the Range specified with the "GS C1" or "GS C;"
	command, the counter will be initialized.
[Default]	Not defined.
[See Also]	GS C0, GS C1, GS c, GS C ;
[Sample Program]			[Print Result]
	See the sample program and print result for the GS C1 command on Page 82.
GS C; N1; N2; N3; N4; N5;
[Function]	Setting the numbering counter mode (B)
[Code]	<1D>H<43>H<3B>H<N1><3B>H<N2><3B>H<N3><3B>H<N4><3B>H
	<N5><3B>H
	<N1>, <N2>, <N3>, <N4>, and <N5> are character codes.
[Range]	0 ≤ N1, N2, N5 ≤ 65535		0 ≤ N3, N4 ≤ 255
[Outline]	This command sets the numbering (serial number counter) mode and a counter value.
	N1		: Counter default
	N2		: Counter final value
	N3		: Counter step value
	N4		: Identical counter print count
	N5		: Counter start value
	N1<N2		: Count-up system
	N1>N2		: Count-down system
	N1	= N2
		or
	N3	= 0	: Counter stop
		or
	N4	= 0