|
|
| |
|
|
|
|
| ESC v | (Serial Interface Only) |
|
| [Function] | Transmitting the printer status | |
| [Code] | <1B> H <76> H | |
| [Outline] | Current printer status is transmitted.. | |
| [Caution] | ∙ Status sent out consists of 1 byte whose content is as in the table below. | |
|
| ∙ In DTR/DSR control, after receptible state of the host (DSR signal being in SPACE state) | |
|
| is confirmed, only 1 byte is transmitted. In XON/XOFF control, DSR signal state not | |
|
| being confirmed, only 1 byte is transmitted. | |
|
| ∙ In DTR/DSR control, when the host is in unreceptible state(DSR signal being in MARK | |
|
| state), it waits until receptible state is created. | |
|
| ∙ In paper end (paper near end) status, this command may be unreceptible state due to | |
|
| BUSY state. | |
Remarks. This command is valid only for serial interface model.
Bit | Function |
| Value | |
0 |
| 1 | ||
|
|
| ||
0 | Not defined |
|
|
|
1 | Not defined |
|
|
|
2 | Paper end | With paper |
| Without paper |
3 | Not defined |
|
|
|
4 | Not used | Fixed to 0 |
| − |
5 | Not defined |
|
|
|
6 | Not defined |
|
|
|
7 | Not defined |
|
|
|
[Sample Program]
OPEN "COM1:N81NN" AS #1 ;
PRINT #1, CHR$ (&H1B) ; "v" ;
A$ = INPUT$ (1, #1) ;
CLOSE #1
END