Netac Tech T600 manual Point-to-Multipoint PMP Mode, Client Mode

Page 13

Netac AirTrack T600 Mini Wireless Router

3.4 Point-to-Multipoint (PMP) Mode

AT600 device operating in Point-to-Multipoint (PMP) Mode wirelessly connects two or more wired networks, as shown in Figure 3.5. The root T600 device (LAN 1) operates in PMP Mode, and the other T600 devices (LAN 2, LAN3) must operate in P2P Mode.

Figure 3.5 PMP Mode (Wireless Bridge)

When operating in PMP Mode, T600 device does not allow client connecting to it directly.

To configure T600 devices to establish a PMP wireless bridge, ensure the following:

1.Enter the MAC address of T600 P2P-1 device and T600 P2P-2 device in the Remote Bridge MAC address field in T600 PMP device (on the PMP Mode Setup page, Figure 5.11).

2.Enter the MAC address of T600 PMP device in the Remote Bridge MAC address field in T600 P2P-1 device and T600 P2P-2 device (on the P2P Mode Setup page, Figure 5.8).

Section 5.4 "PMP Mode Setup Page" describes the configuration details for this mode.

3.5 Client Mode

When T600 operate in Client Mode, T600 device associates to an AP within its range in infrastructure mode, as shown in Figure 3.6, or joins with another Client Mode T600 device in an Ad-Hoc network, as shown in Figure 3.7. In Client Mode, T600 operates as a normal wireless client.

8

Image 13

Contents Netac AirTrack T600 Mini Wireless Router Remarks Radio Frequency Interference Remarks Table of Contents Appendix B Contact Netac Appendix C Glossary Introduction ChecklistWelcome Product functionAppearances AppearanceUpside Quick Start Default Factory SettingsAP Router Mode Operating Mode OverviewRepeater Mode Repeater Mode Parent/Child MAC Addresses Point-to-Point P2P ModeClient Mode Point-to-Multipoint PMP ModeClient in Infrastructure Mode WEP WPA-PSK Wireless Security SupportAP Router Mode Setup Mode SelectionField Description WEP Configuration AP Router Mode Security ConfigurationAP Router Mode WPA Configuration AP Router Mode Advanced SettingsConnect Repeater AP Router Mode Access Filter MAC Filter List SetupAP Router Mode Access Filter Repeater Mode SetupRepeater Mode Setup Repeater Mode Setup Options Repeater Mode Security Configuration Repeater Mode Access Filter MAC Filter List Setup Repeater Mode Advanced SettingsP2P Mode Setup 11 P2P Mode Setup Options P2P Mode Setup2 P2P Mode Advanced Settings 1 P2P Mode Security Configuration10 P2P Mode Advanced Settings PMP Mode Setup11 PMP Mode Setup 14 PMP Mode Setup Options PMP Mode Security Configuration12 PMP Mode Advanced Settings 16 PMP Mode Advanced Settings PMP Mode Advanced SettingsStation Mode Select 802.11b or 802.11g mode Client Mode Setup14 Client Mode Site Survey 18 Client Mode Site Survey Client Mode Site Survey15 and .19 detail the WEP configuration page for Client Mode Client Mode Security Configuration16 and .20 detail the WPA configuration for Client Mode Status AP Router Mode StatusRepeater Mode Status P2P Mode Status Client Mode Status AP Router Mode Admin AdminReconfirm Password fields and click Apply Same subnet LANNetac AirTrack T600 Mini Wireless Router Access to the device that provides the IP address Same subnet WAN OtherForward DMZ LED SpecificationsMy question is not included in FAQ, what shall I do? Appendix a FAQAppendix B Contact Netac 802.11b Appendix C GlossaryCCK LAN Wlan