Monarch 9406 manual Print Position

Page 20

9406 Operator's Handbook

The printer does not stop between labels in continuous mode, but you can interrupt the batch. Press Q in the middle of the batch to suspend printing and bring the printer to the Pause menu. Then, you can change the supply, printer values, etc. and resume printing (or cancel the batch). If you enter new values and resume printing, the printer finishes the current batch. It only uses the new values when you print another batch (unless described otherwise under that feature in this manual).

Print Position

This function adjusts where data prints vertically on the supply. You can adjust the print if it is too close to the top or bottom of the supply, or goes over the pre-printed area ("MONARCH" in the sample below). The adjustments are in dots (0.0052 inch), which is the smallest measurement the printer recognizes. The range is from -999 to +999 (5.20 inches), and the default is 0.

NOTE: If you change this value in the middle of a batch, the change is immediate. It does not wait for the next batch to make the change. Alter the number as follows:

∙If the data is too close to the bottom of the supply, increase the number.

∙If the data is too close to the top of the supply, decrease the number.

3-6

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Operators Handbook Canadian D.O.C. Warning Table of Contents Operators Handbook Introduction About This ManualOther Documentation Menu StructureIntroduction New 9406 Features Terms You Should Know Operators Handbook Getting Started Using the Keypad Turning the Printer OnSelecting a Function Print ModeStart Up Exiting an Option Main MenuSetting Supply Options Finding the Supply OptionsSetup RibbonSupply RibbonSupply Type Supply TypeDispense Mode Continuous Mode Features Dispense ModePrint Position Supply Supply Position Margin Position Print too far to the leftMargin Pos Setting Supply Options Operators Handbook Setting Communication Values Finding Communication Value OptionsBaud Rate Baud RateWord Length Word LengthStopbits Port SettingsStop Bits Parity ParityXON/XOFF DTR Flow ControlFlow Control DTR Reset to Default Values Port Settings Setting the Contrast Contrast Press Q to exit to the Main Menu Setting Defaults Finding Default OptionsMonetary Sign USASecondary Sign Monetary SignDefaults Secondary SignDecimal Places Decimal PlacesOperators Handbook Printing Online Print Mode Press E . You will see Index Index-1Index-2 Page U.S.A Canada
Top Page Image Contents