Monarch 9406 manual Margin Position, Print too far to the left

Page 23

3. Setting Supply Options

5.Press Q to exit to the Setup menu.

6.Press Q to exit to the Main Menu.

NOTE: After changing settings in the Setup Menu, always return to the Main Menu before turning your printer off. The printer will not save changes to these menus if you turn it off before returning to the Main Menu.

Margin Position

This function adjusts where the format prints horizontally on the supply. The adjustments are in dots (0.0052 inch), which is the smallest measurement the printer recognizes. The range is -99 to +99 (0.52 inches), and the default is 0.

NOTE: If you change the Margin position in the middle of the batch, the change does not occur until the next batch, except for variable data, such as incrementing or decrementing fields. The changes occur immediately in variable data fields.

Print too far to the left.

Print too far to the right.

Use the following rules of thumb as you set this position:

If the data is too close to the left side of the supply, increase the number.

If the data is too close to the right side of the supply, decrease the number.

Setting Supply Options

3-9

Image 23
Contents Operators Handbook Canadian D.O.C. Warning Table of Contents Operators Handbook About This Manual IntroductionMenu Structure Other DocumentationIntroduction New 9406 Features Terms You Should Know Operators Handbook Getting Started Turning the Printer On Using the KeypadSelecting a Function Print ModeStart Up Main Menu Exiting an OptionFinding the Supply Options Setting Supply OptionsRibbon SetupRibbon SupplySupply Type Supply TypeDispense Mode Dispense Mode Continuous Mode FeaturesPrint Position Supply Supply Position Print too far to the left Margin PositionMargin Pos Setting Supply Options Operators Handbook Finding Communication Value Options Setting Communication ValuesBaud Rate Baud RateWord Length Word LengthStopbits Port SettingsStop Bits Parity ParityXON/XOFF DTR Flow ControlFlow Control DTR Reset to Default Values Port Settings Setting the Contrast Contrast Press Q to exit to the Main Menu Finding Default Options Setting DefaultsUSA Monetary SignMonetary Sign Secondary SignSecondary Sign DefaultsDecimal Places Decimal PlacesOperators Handbook Printing Online Print Mode Press E . You will see Index-1 IndexIndex-2 Page U.S.A Canada