Monarch 9406 manual Word Length

Page 29

Setting the Communication Values

2.Press R or L to display the baud rate you need, then press E . You will see

PORT SETTINGS
Baud rate	>

3.Press Q to exit to the Setup menu.

4.Press Q to exit to the Main Menu.

NOTE: After changing settings in the Setup Menu, always return to the Main Menu before turning your printer off. The printer will not save changes to these menus if you turn it off before returning to the Main Menu.

Word Length

The default setting for Word Length is 8. To change the setting, follow the steps listed under "Finding Communication Value Options." Then follow the steps below.

1.Press R until you see

	PORT SETTINGS
<	Word Length	>

2.Press E . You will see the previous setting, for example,

WORD LENGTH

<8

The options for Word Length are

7

8

4-3

Values	Setting Communication

Image 29

Contents Operators Handbook Canadian D.O.C. Warning Table of Contents Operators Handbook About This Manual IntroductionMenu Structure Other DocumentationIntroduction New 9406 Features Terms You Should Know Operators Handbook Getting Started Turning the Printer On Using the KeypadSelecting a Function Print ModeStart Up Main Menu Exiting an OptionFinding the Supply Options Setting Supply OptionsRibbon SetupSupply RibbonSupply Type Supply TypeDispense Mode Dispense Mode Continuous Mode FeaturesPrint Position Supply Supply Position Print too far to the left Margin PositionMargin Pos Setting Supply Options Operators Handbook Finding Communication Value Options Setting Communication ValuesBaud Rate Baud RateWord Length Word LengthStopbits Port SettingsStop Bits Parity ParityXON/XOFF DTR Flow ControlFlow Control DTR Reset to Default Values Port Settings Setting the Contrast Contrast Press Q to exit to the Main Menu Finding Default Options Setting DefaultsUSA Monetary SignMonetary Sign Secondary SignSecondary Sign DefaultsDecimal Places Decimal PlacesOperators Handbook Printing Online Print Mode Press E . You will see Index-1 IndexIndex-2 Page U.S.A Canada