Monarch 9406 manual Ribbon, Setup, Supply

Page 16

9406 Operator's Handbook

2.Press E . You will see

SETUP

Supply >

3.Press E . You will see the first supply option.

SUPPLY

Ribbon >

To change one of these options, follow the instructions under the correct heading. To exit an option without changing the setting, press Q .

Ribbon

You can print with or without a ribbon, but you have to tell the printer which option you want.

The default setting for ribbon is Yes. To change the setting, follow the steps under "Finding the Supply Options." Then follow the steps below.

1.Press E to set the ribbon option. You will see the previous setting, for example

RIBBON

<Yes

2.Press R or L until you see the option you want. Then press E . You will see

SUPPLY

Ribbon >

3-2

Image 16

Contents Operators Handbook Canadian D.O.C. Warning Table of Contents Operators Handbook Introduction About This ManualOther Documentation Menu StructureIntroduction New 9406 Features Terms You Should Know Operators Handbook Getting Started Using the Keypad Turning the Printer OnStart Up Print ModeSelecting a Function Exiting an Option Main MenuSetting Supply Options Finding the Supply OptionsSetup RibbonSupply RibbonSupply Type Supply TypeDispense Mode Continuous Mode Features Dispense ModePrint Position Supply Supply Position Margin Position Print too far to the leftMargin Pos Setting Supply Options Operators Handbook Setting Communication Values Finding Communication Value OptionsBaud Rate Baud RateWord Length Word LengthStop Bits Port SettingsStopbits Parity ParityFlow Control DTR Flow ControlXON/XOFF DTR Reset to Default Values Port Settings Setting the Contrast Contrast Press Q to exit to the Main Menu Setting Defaults Finding Default OptionsMonetary Sign USASecondary Sign Monetary SignDefaults Secondary SignDecimal Places Decimal PlacesOperators Handbook Printing Online Print Mode Press E . You will see Index Index-1Index-2 Page U.S.A Canada