Monarch 9406 manual Port Settings

Page 34

9406 Operator's Handbook

2.Press E . You will see

Are you sure?

No >

3.You can:

press Q to exit without changing the values. You will return to the Port Setting menu.

press R and then E to set the values to the defaults. You will see

PORT SETTINGS

<Reset

4.Press Q to exit to the Setup menu.

5.Press Q to exit to the Main Menu.

NOTE: After changing settings in the Setup Menu, always return to the Main Menu before turning your printer off. The printer will not save changes to these menus if you turn it off before returning to the Main Menu.

6.Verify that the default settings are correct by printing Test Label 2 (the current communication parameters appear on the label). See "Printing a Test Label" in Read This First.

4-8

Image 34
Contents Operators Handbook Canadian D.O.C. Warning Table of Contents Operators Handbook Introduction About This ManualOther Documentation Menu StructureIntroduction New 9406 Features Terms You Should Know Operators Handbook Getting Started Using the Keypad Turning the Printer OnStart Up Print ModeSelecting a Function Exiting an Option Main MenuSetting Supply Options Finding the Supply OptionsSupply SetupRibbon RibbonSupply Type Supply TypeDispense Mode Continuous Mode Features Dispense ModePrint Position Supply Supply Position Margin Position Print too far to the leftMargin Pos Setting Supply Options Operators Handbook Setting Communication Values Finding Communication Value OptionsBaud Rate Baud RateWord Length Word LengthStop Bits Port SettingsStopbits Parity ParityFlow Control DTR Flow ControlXON/XOFF DTR Reset to Default Values Port Settings Setting the Contrast Contrast Press Q to exit to the Main Menu Setting Defaults Finding Default OptionsMonetary Sign USASecondary Sign Monetary SignDefaults Secondary SignDecimal Places Decimal PlacesOperators Handbook Printing Online Print Mode Press E . You will see Index Index-1Index-2 Page U.S.A Canada