Monarch 9406 manual Flow Control DTR, Xon/Xoff Dtr

Page 32

9406 Operator's Handbook

3.Press R or L to display the parity you need, then press E . You will see

PORT SETTINGS

< Parity >

4.Press Q to exit to the Setup menu.

5.Press Q to exit to the Main Menu.

NOTE: After changing settings in the Setup Menu, always return to the Main Menu before turning your printer off. The printer will not save changes to these menus if you turn it off before returning to the Main Menu.

Flow Control

The default setting for Flow Control is DTR. To change the setting, follow the steps listed under "Finding Communication Value Options." Then follow the steps below.

1.Press R until you see

	PORT SETTINGS
<	Flow Control	>

2.Press E . You will see the previous setting, for example,

FLOW CONTROL

<DTR

The options for flow control are

None

XON/XOFF

DTR

4-6

Image 32

Contents Operators Handbook Canadian D.O.C. Warning Table of Contents Operators Handbook Introduction About This ManualOther Documentation Menu StructureIntroduction New 9406 Features Terms You Should Know Operators Handbook Getting Started Using the Keypad Turning the Printer OnSelecting a Function Print ModeStart Up Exiting an Option Main MenuSetting Supply Options Finding the Supply OptionsSetup RibbonSupply RibbonSupply Type Supply TypeDispense Mode Continuous Mode Features Dispense ModePrint Position Supply Supply Position Margin Position Print too far to the leftMargin Pos Setting Supply Options Operators Handbook Setting Communication Values Finding Communication Value OptionsBaud Rate Baud RateWord Length Word LengthStopbits Port SettingsStop Bits Parity ParityXON/XOFF DTR Flow ControlFlow Control DTR Reset to Default Values Port Settings Setting the Contrast Contrast Press Q to exit to the Main Menu Setting Defaults Finding Default OptionsMonetary Sign USASecondary Sign Monetary SignDefaults Secondary SignDecimal Places Decimal PlacesOperators Handbook Printing Online Print Mode Press E . You will see Index Index-1Index-2 Page U.S.A Canada