Monarch 9406 manual Stop Bits, Port Settings, Stopbits

Page 30

9406 Operator's Handbook

3.Press L or Rr to display the word length you need, then press E . You will see

	PORT SETTINGS
<	Word Length	>

4.Press Q to exit to the Setup menu.

5.Press Q to exit to the Main Menu.

NOTE: After changing settings in the Setup Menu, always return to the Main Menu before turning your printer off. The printer will not save changes to these menus if you turn it off before returning to the Main Menu.

Stop Bits

The default setting for Stop Bits is 1. To change the setting, follow the steps listed under "Finding Communication Value Options." Then follow the steps below.

1.Press R until you see

PORT SETTINGS

< Stopbits >

2.Press E . You will see the previous setting, for example,

STOPBITS

1>

The options for Stop Bits are

1

2

4-4

Image 30

Contents Operators Handbook Canadian D.O.C. Warning Table of Contents Operators Handbook Introduction About This ManualOther Documentation Menu StructureIntroduction New 9406 Features Terms You Should Know Operators Handbook Getting Started Using the Keypad Turning the Printer OnPrint Mode Start UpSelecting a Function Exiting an Option Main MenuSetting Supply Options Finding the Supply OptionsSupply SetupRibbon RibbonSupply Type Supply TypeDispense Mode Continuous Mode Features Dispense ModePrint Position Supply Supply Position Margin Position Print too far to the leftMargin Pos Setting Supply Options Operators Handbook Setting Communication Values Finding Communication Value OptionsBaud Rate Baud RateWord Length Word LengthPort Settings Stop BitsStopbits Parity ParityFlow Control Flow Control DTRXON/XOFF DTR Reset to Default Values Port Settings Setting the Contrast Contrast Press Q to exit to the Main Menu Setting Defaults Finding Default OptionsMonetary Sign USASecondary Sign Monetary SignDefaults Secondary SignDecimal Places Decimal PlacesOperators Handbook Printing Online Print Mode Press E . You will see Index Index-1Index-2 Page U.S.A Canada