Monarch 9406 manual Secondary Sign, Monetary Sign

Page 39

6. Setting Defaults

The default setting for Monetary Sign is USA. To change the setting, follow the steps listed under "Finding Default Options." Then follow the steps below.

1.Press E . You will see the previous setting, for example

MONETARY SIGN

< USA >

2.Press R or L until you see the country for the monetary sign you want.

3.Press E . You will see

DEFAULTS

 

Monetary Sign

>

4.Press Q to exit to the Setup menu.

5.Press Q to exit to the Main Menu.

NOTE: After changing settings in the Setup Menu, always return to the Main Menu before turning your printer off. The printer will not save changes to these menus if you turn it off before returning to the Main Menu.

Secondary Sign

If you select USA as the monetary sign, you can print amounts less than $1.00 either by using a dollar sign and decimal ($ .30) or by using a cent sign (30¢). Note the following facts:

If you set the secondary sign option to No, prices under $1.00 will print like this: $ .45

If you set the secondary sign option to Yes, prices under $1.00 will print like this: 45¢

The same option applies to monetary signs other than USA.

Setting Defaults

6-3

Image 39
Contents Operators Handbook Canadian D.O.C. Warning Table of Contents Operators Handbook About This Manual IntroductionMenu Structure Other DocumentationIntroduction New 9406 Features Terms You Should Know Operators Handbook Getting Started Turning the Printer On Using the KeypadPrint Mode Start UpSelecting a Function Main Menu Exiting an OptionFinding the Supply Options Setting Supply OptionsRibbon SetupRibbon SupplySupply Type Supply TypeDispense Mode Dispense Mode Continuous Mode FeaturesPrint Position Supply Supply Position Print too far to the left Margin PositionMargin Pos Setting Supply Options Operators Handbook Finding Communication Value Options Setting Communication ValuesBaud Rate Baud RateWord Length Word LengthPort Settings Stop BitsStopbits Parity ParityFlow Control Flow Control DTRXON/XOFF DTR Reset to Default Values Port Settings Setting the Contrast Contrast Press Q to exit to the Main Menu Finding Default Options Setting DefaultsUSA Monetary SignMonetary Sign Secondary SignSecondary Sign DefaultsDecimal Places Decimal PlacesOperators Handbook Printing Online Print Mode Press E . You will see Index-1 IndexIndex-2 Page U.S.A Canada