Meridian Data 16i manual I2C Monitoring, Failed Devices

Chapter 3 Subsystem Monitoring

	Upper Threshold	Lower Threshold
+3.3V	+3.6V	+2.9V
+5V	+5.5V	+4.5V
+12V	+13.2V	+10.8V
CPU Temperature	90ºC	5ºC
Controller Board	80ºC	5ºC
Temperature
Enclosure Ambient	40ºC	0ºC
Temperature

Table 3-7: Default Threshold Values

3.3.2 Failed Devices

If any of the following components fails, the audible alarm will be triggered:

•RAID controller module

•Cooling fan modules

•PSU modules

•BBU module

•Hard disk drives

NOTE:

When temperature exceeds a preset threshold, the controller’s charger circuits will stop charging. You will then receive a message that says “Thermal Shutdown/Enter Sleep Mode.” When the temperature falls back within normal range, the battery will resume charging.

3.4 I2C Monitoring

Formatted: Bullets and Numbering

Deleted: ¶

The operating status of PSU and cooling fan modules are collected through an I2C serial bus. If either of these modules fails, the failure will be detected and you will be notified through the various methods described above.

3-9