®
27
WR1500 4-Port Wireless DSL/Cable Router
PROBLEM | CORRECTIVE ACTION |
None of the LED’s turn on when I plug in the power adaptor.
I cannot access the WR1500
Make sure you are using the supplied power adaptor and that it is plugged in to an appropriate power source. Check that the power source is turned on. If the problem persists, you may have a hardware problem. In this case, you should contact your local vendor.
1.Check to see if the WR1500 Access Point is connected to your computer’s console port.
Access Point via the console port.
2.Check to see if the communications program is confi gured correctly. The communications software should be confi gured as follows:
VT100
terminal emulation.
9600 bps is the default speed on leaving the factory. Try other speeds in case
the speed has been
.