®
6
WR1500
Changing the IP Address
Step 1. On the LAN screen, change the IP Pool Starting Address (Box 1 on the illustration below; 192.168.1.33 by default) to the recommended setting of 192.168.2.33.
LAN
IP
DHCP Setup
DHCP Server
1 | IP Pool Starting Address | 192.168.1.33 | Pool Size | 32 |
| ||||
| DNS Servers Assigned by DHCP Server |
|
| |
| First DNS Server | From ISP | 0.0.0.0 |
|
| Second DNS Server From ISP | 0.0.0.0 |
| |
| Third DNS Server | From ISP | 0.0.0.0 |
|
2 | LAN TCP/IP |
|
|
|
IP Address | 192.168.2.1 | RIP Direction Both | ||
| IP Subnet Mask | 255.255.255.0 | RIP Version | |
| Multicast | None |
|
|
| Windows Networking (NetBIOS over TCP/IP) |
|
| |
| Allow between LAN and WAN |
|
| |
|
|
| Apply | Reset |
Step 2. Change the IP Address (Box 2 on the illustration below; set to 192.168.1.1 by default) to the recommended setting of 192.168.2.1.
Step 3. Click Apply at the bottom of the screen to save the settings. Clicking Apply will cause you to lose your connection to the Web Confi guration Utility.
Step 4. Turn off power to both the WR1500 and cable/DSL modem.
Reconnecting the cable/DSL modem
Step 1. While both are powered off, reconnect the cable/ DSL modem to the WAN port on the WR1500. (See
Step 1 and Step 2 in the WR1500 Quick Start Guide).
Step 2. Power the router back on, wait until the status lights are normal.
Step 3. Power the cable/DSL modem.
After you have performed these steps you should reboot the computer and test the LAN/WAN connectivity. If you are still having issues, ParkerVision Technical Support is available at 800.231.1759 or at support@parkervision.com.