ParkerVision WR1500 quick start Installation

Page 3

®

4

WR1500 4-Port Wireless DSL/Cable Router

Start Here!

INSTALLATION

This section will guide you through the installation of the WR1500.

Unpack your WR1500 and make sure that everything is unwrapped and ready to begin.

First, either install, or make sure the antennas for the WR1500 are securely installed onto the rear panel of the unit.

A CAT-5 Ethernet Cable is supplied to connect between your computer and the WR1500. A picture of this type of cable is shown below.

Also shown below is an illustration of a typical installation for the WR1500.

The next page will describe the speciﬁcs of making these connections.

Image 3

Contents Guide Package Contents Installation Next Changing the IP Address Rear panel of the WR1500 contains several ports, as shown Make the connections as described belowEstablishing Contact on Your Computer with the WR1500 Again You should now see the Main Menu screen, as shown below Label Description Set up your wireless LAN using the wizard screen below Wizard Setup Wireless LAN SetupAscii Select from Standard, RR-Toshiba Minutes from 1 to 59 30 recommended for Pptp Pptp EncapsulationPptp Conﬁguration PPPoE Encapsulation Wizard WAN IP Address Assignment Wizard Setup WAN and DNSIP Address and Subnet Mask WAN MAC Address DNS Server Address AssignmentWizard WR1500 4-Port Wireless DSL/Cable Router Saving and Restoring Your Configuration Basic Setup of Your WR1500 is Now CompleteProcedure to Use the Reset Button Problem Corrective Action Troubleshooting the Ethernet Interface Problems with the Ethernet InterfaceWR1500 4-Port Wireless DSL/Cable Router Internet Access chapter SMT