ParkerVision WR1500 quick start Make the connections as described below

Page 6

®

7

WR1500 4-Port Wireless DSL/Cable Router

Make the connections as described below.

The rear panel of the WR1500 contains several ports, as shown:

Plug your computer’s Ethernet

Plug your cable or DSL

Plug the AC Adapter

cable into Port 1. The

remaining ports can to be used

modem’s Ethernet

into this port.

with other computers in a

Cable into this port.

 

hard-wired router fashion.

 

 

For initial setup, you should have:

The power adapter plugged into the WR1500 as shown, and this adapter plugged into a surge-protected electrical outlet.

Your Cable or DSL modem’s Ethernet cable plugged into the Internet-In port as shown above.

An Ethernet cable plugged into the router port 1 as shown above, and the other end of this cable plugged into your computer’s Ethernet port.

Proceed to the Next Page to Begin Setting Up Your WR1500.

Image 6
Contents Guide Package Contents Installation Next Changing the IP Address Make the connections as described below Rear panel of the WR1500 contains several ports, as shownEstablishing Contact on Your Computer with the WR1500 Again You should now see the Main Menu screen, as shown below Label Description Wizard Setup Wireless LAN Setup Set up your wireless LAN using the wizard screen belowAscii Select from Standard, RR-Toshiba Minutes from 1 to 59 30 recommended for Pptp Encapsulation PptpPptp Configuration PPPoE Encapsulation Wizard Wizard Setup WAN and DNS WAN IP Address AssignmentIP Address and Subnet Mask DNS Server Address Assignment WAN MAC AddressWizard WR1500 4-Port Wireless DSL/Cable Router Basic Setup of Your WR1500 is Now Complete Saving and Restoring Your ConfigurationProcedure to Use the Reset Button Problem Corrective Action Problems with the Ethernet Interface Troubleshooting the Ethernet InterfaceWR1500 4-Port Wireless DSL/Cable Router Internet Access chapter SMT