ParkerVision WR1500 quick start Again

Page 8

®

9

WR1500 4-Port Wireless DSL/Cable Router

Note - If the default password of “1234” is not accepted, refer to page 17 of this guide and go through the reset procedure to set all parameters back to factory defaults. Then try the above steps

again.

If you do not see the log-in window, go back and double check that the WR1500 is powered on, and that the Ethernet Cable between it and your computer is plugged in securely. If, after checking these items, you still cannot make contact with the WR1500, you may want to try a different Ethernet Cable. Also, refer to the troubleshooting section in the appendix of this quick start guide. If you still have

difﬁ culty with installation, contact support at 800-231-1759 or support@direct2data.com.

Image 8

Contents Guide Package Contents Installation Next Changing the IP Address Make the connections as described below Rear panel of the WR1500 contains several ports, as shownEstablishing Contact on Your Computer with the WR1500 Again You should now see the Main Menu screen, as shown below Label Description Wizard Setup Wireless LAN Setup Set up your wireless LAN using the wizard screen belowAscii Select from Standard, RR-Toshiba Minutes from 1 to 59 30 recommended for Pptp Encapsulation PptpPptp Conﬁguration PPPoE Encapsulation Wizard Wizard Setup WAN and DNS WAN IP Address AssignmentIP Address and Subnet Mask DNS Server Address Assignment WAN MAC AddressWizard WR1500 4-Port Wireless DSL/Cable Router Basic Setup of Your WR1500 is Now Complete Saving and Restoring Your ConfigurationProcedure to Use the Reset Button Problem Corrective Action Problems with the Ethernet Interface Troubleshooting the Ethernet InterfaceWR1500 4-Port Wireless DSL/Cable Router Internet Access chapter SMT