ParkerVision WR1500 Problems with the Ethernet Interface, Troubleshooting the Ethernet Interface

Page 27

®

28

WR1500 4-Port Wireless DSL/Cable Router

Appendix 2 - Troubleshooting the WR1500 Initial Setup and Installation - Continued

Use the RESET button on the side panel of the WR1500 Wireless Router to restore the factory default conﬁ guration ﬁ le (hold this button in for more than ﬁ ve seconds). This will restore all of the factory defaults including the password.

Problems with the Ethernet Interface

Troubleshooting the Ethernet Interface

PROBLEM	CORRECTIVE ACTION
I cannot access	If all of the LAN LED’s on the front panel
the WR1500	are off, check the Ethernet cable connection
Wireless Router	between your WR1500 Wireless Router and

from the Ethernet the computer connected to the LAN port.

Check for faulty Ethernet cables. Make sure the computer’s Ethernet adapter is installed and working properly or

Verify that the IP addresses and the subnet

Continued next page

Image 27

Contents Guide Package Contents Installation Next Changing the IP Address Rear panel of the WR1500 contains several ports, as shown Make the connections as described belowEstablishing Contact on Your Computer with the WR1500 Again You should now see the Main Menu screen, as shown below Label Description Set up your wireless LAN using the wizard screen below Wizard Setup Wireless LAN SetupAscii Select from Standard, RR-Toshiba Minutes from 1 to 59 30 recommended for Pptp Pptp EncapsulationPptp Conﬁguration PPPoE Encapsulation Wizard WAN IP Address Assignment Wizard Setup WAN and DNSIP Address and Subnet Mask WAN MAC Address DNS Server Address AssignmentWizard WR1500 4-Port Wireless DSL/Cable Router Saving and Restoring Your Configuration Basic Setup of Your WR1500 is Now CompleteProcedure to Use the Reset Button Problem Corrective Action Troubleshooting the Ethernet Interface Problems with the Ethernet InterfaceWR1500 4-Port Wireless DSL/Cable Router Internet Access chapter SMT