Pioneer VSX-919AH-S Power ON Level Setup, Volume Limit Setup, The system and the other setup

The system and the other setup 11

•Fixed – Use this setting if you’ve connected a fully integrated amplifier (such as another Pioneer VSX receiver) in the sub room and want to use that receiver’s volume controls.

With the Fixed setting, the source is sent from this receiver at maximum volume, so make sure the volume is quite low in the sub zone at first, and then experiment to find the correct level.

3When you’re finished, press RETURN. You will return to the Other Setup menu.

Power ON Level Setup

The volume can be set so that it is always set to the same level when the receiver’s power is turned on.

1Select ‘Power ON Level Setup’ from the Other Setup menu.

4d.Other Setup

A/V RECEIVER

1.KURO LINK Setup

2.Multi Ch In Setup

3.ZONE Audio Setup

4.Power ON Level Setup

5.Volume Limit Setup

6.Remote Control Mode Setup

7.Flicker Reduction Setup

4d4.Power ON Level Setup
	A/V RECEIVER
Power ON Level	:	LAST
Exit		Return
Exit		Finish

2Select the Power ON Level setting you want.

•LAST – When the power is turned on, the volume is set to the same level as when the power was last turned off.

•“---” – When the power is turned on, the volume is set to minimum level.

•-80.0dBto +12.0dB – Specify the volume to be set when the power is turned, in steps of 0.5 dB.

It is not possible to set a volume level greater than the value specified at Volume Limit Setup.

3When you’re finished, press RETURN. You will return to the Other Setup menu.

Volume Limit Setup

Use this function to limit the maximum volume. The volume cannot be increased above the level set here, even by operating MASTER VOLUME button (or the dial on the front panel).

1Select ‘Volume Limit Setup’ from the Other Setup menu.

4d.Other Setup

A/V RECEIVER

1.KURO LINK Setup

2.Multi Ch In Setup

3.ZONE Audio Setup

4.Power ON Level Setup

5.Volume Limit Setup

6.Remote Control Mode Setup

7.Flicker Reduction Setup

4d5.Volume Limit Setup
	A/V RECEIVER
Volume Limit :	OFF
Exit	Return
Exit	Finish

2Select the Volume Limit setting you want.

•OFF – The maximum volume is not limited.

•-20.0dB/-10.0dB/0.0dB – The maximum volume is limited to the value set here.

3When you’re finished, press RETURN. You will return to the Other Setup menu.

99

En