Pioneer VSX-919AH-S manual Plugging in the receiver, Socket on the back of the receiver

Connecting your equipment 03

				1 Plug the supplied power cord into the AC
Plugging in the receiver
				IN socket on the back of the receiver.
After you’ve finished making all connections,				2 Plug the other end into a power outlet.1
plug the receiver into an AC outlet. The type of
cord and the plug converter which can be used				CAUTION
depends on the power voltage in each region or
country. Please make sure you use the correct				• Handle the power cord by the plug part. Do
cord and plug converter due to the possibility				not pull out the plug by tugging the cord,
of fire or other hazard if used incorrectly (see				and never touch the power cord when your
below).				hands are wet, as this could cause a short
				circuit or electric shock. Do not place the
AC power cord and converter plug use
				unit, a piece of furniture, or other object on
Region	Plug type			the power cord or pinch the cord in any
				other way. Never make a knot in the cord or
For European type region
				tie it with other cables. The power cords
Caution
Do not use this power				should be routed so that they are not likely
cord set in Singapore and	European two-pin plug			to be stepped on. A damaged power cord
Malaysia.				can cause a fire or give you an electric
				shock. Check the power cord once in a
For regions with two pin
flat-bladed plug				while. If you find it damaged, ask your
Caution				nearest Pioneer authorized independent
Do not use this power	European two-pin plug with			service company for a replacement.
cord set in Taiwan.
	two-pin flat-bladed converter			• Do not use any power cord other than the
			plug	one supplied with this unit.
For Taiwan exclusively				• Do not use the supplied power cord for any
Caution				purpose other than that described below.
For use in Taiwan only. In				• The receiver should be disconnected by
other areas, please do	Taiwanese two-pin flat-
not use.				removing the mains plug from the wall
		bladed plug
				socket when not in regular use, e.g., when
For Australian and New				on vacation.
Zealand exclusively				• Make sure the blue  STANDBY/ON light

AS 3112 flat two-pin plug	has gone out before unplugging.
	• If you have connected speakers with a 6 Ω
	impedance, change the impedance setting
	before turning on the power.

Note

1After this receiver is connected to an AC outlet, a 2 second to 10 second HDMI initialization process begins. You cannot carry out any operations during this process. The HDMI indicator in the front panel display blinks during this process, and you can turn on this receiver once it has stopped blinking. When you set the KURO LINK mode to OFF, you can skip this process. For details about the KURO LINK feature, see KURO LINK on page 59.

35

En