Pioneer VSX-919AH-S Remote control, 12Additional information, Remote Control Mode Setup on page

12Additional information

Symptom

During playback of a Surround EX or DTS-ES source on the SBch AUTO setting, EX or ES does not appear, or the signal is not properly processed.

Remedy

•The source may be Dolby Surround EX/DTS-ES software, but it has no flag to indicate it is 6.1 compatible. Set to SBch ON (see Using surround back channel processing on page 55), then switch to the Standard EX listening mode (see Listening in surround sound on page 52).

During playback of DVD- Audio, the display shows PCM.

•This will occur when playing DVD-Audio material over the HDMI connection. This is not a malfunction.

The power turns off	• See the Power section (page 101).
automatically and some
indicator flashes, or some
indicator flashes and the
power does not turn on.

Remote control

SymptomRemedy

Cannot be remote controlled. • Set a 5-digit preset code corresponding to the receiver to be operated in the remote control (see Operating multiple receivers on page 72).

	• Check whether the receiver’s remote control mode is properly set (see
	Remote Control Mode Setup on page 100).
	• Try replacing the batteries in the remote control (see Loading the batteries on
	page 7).
	• Be sure to operate within 7 m and a 30º angle of the remote sensor on the
	front panel (see Operating range of remote control unit on page 13).
	• Check that there are no obstacles between the receiver and the remote
	control.
	• Make sure that there is no fluorescent or other strong light shining on to the
	remote sensor.
	• Check the connections of the CONTROL IN jack (see Operating other Pioneer
	components with this unit’s sensor on page 32).
Other components can’t be	• If the battery ran down, the preset codes may have been cleared. Re-enter the
operated with the system	preset codes.
remote.	• The preset code may be incorrect. Redo the procedure for entering preset
	codes.

108

En