Pioneer VSX-919AH-S manual Connecting your equipment Connecting an IR receiver

03Connecting your equipment

Connecting an IR receiver

If you keep your stereo components in a closed cabinet or shelving unit, or you wish to use the sub zone remote control in another zone, you can use an optional IR receiver (such as a Niles or Xantech unit) to control your system instead

of the remote sensor on the front panel of this receiver.1

1Connect the IR receiver sensor to the IR IN jack on the rear of this receiver.

Closet or shelving unit

Non-Pioneer Pioneer

component component

IR					CONTROL
IN					IN	OUT
								HDMI
							ASSIGNABLE
								1	3
ASSIGNABLE	BD IN	IN 1		IN 2	IN 3		OUT
		AUDIO
Y	Y	L
PB	PB	R
		ZONE 2	DVD	TV/SAT	DVR		AUX	CD
PR	PR	OUT	IN	IN	OUT	IN	IN	IN
IN 1	IN 2								SP
(DVD)	(DVR)								A
	MONITOR
Y	OUT						IN
							IR
PB	VIDEO						OUT
							IN
							CON-
PR							TROL
							OUT
COMPONENT
VIDEO
VSX-1019AH

IR receiver

2Connect the IR IN jack of another component to the IR OUT jack on the rear of this receiver to link it to the IR receiver. Please see the manual supplied with your IR receiver for the type of cable necessary for the connection.

•If you want to link a Pioneer component to the IR receiver, see Operating other Pioneer components with this unit’s sensor below to connect to the CONTROL jacks instead of the IR OUT jack.

Operating other Pioneer components with this unit’s sensor

Many Pioneer components have SR CONTROL jacks which can be used to link components together so that you can use just the remote sensor of one component. When you use a remote control, the control signal is passed along the chain to the appropriate component.2

Important

•Note that if you use this feature, make sure that you also have at least one set of analog audio, video or HDMI jacks connected to another component for grounding purposes.

1Decide which component you want to use the remote sensor of.

When you want to control any component in the chain, this is the remote sensor at which you’ll point the corresponding remote control.

Note

1• Remote operation may not be possible if direct light from a strong fluorescent lamp is shining on the IR receiver remote sensor window.

•Note that other manufacturers may not use the IR terminology. Refer to the manual that came with your component to check for IR compatibility.

•If using two remote controls (at the same time), the IR receiver’s remote sensor takes priority over the remote sensor on the front panel.

2• If you want to control all your components using this receiver’s remote control, see Setting the remote to control other components on page 72.

•If you have connected a remote control to the CONTROL IN jack (using a mini-plug cable), you won’t be able to control this unit using the remote sensor.

32

En