Pioneer VSX-919AH-S Professional Calibration EQ graphical output, Display, Additional information

Additional information 12

Professional Calibration EQ graphical output

Symptom	Remedy
The EQ response displayed in	• There are cases where the graph does not appear flat (even when selecting
the graphical output	ALL CH ADJ in the Auto MCACC Setup) due to adjustments made to
following calibration does not	compensate for room characteristics to achieve optimal sound.
appear entirely flat.	• Areas of the graph may appear identical (before and after) when there is little
	or no adjustment needed.
	• The graph may appear to have shifted vertically when comparing before and
	after measurements.
EQ adjustments made using	• Despite level adjustments being made, the filters used for analysis may not
the Manual MCACC setup on	display these adjustments in the graphical output. However, these adjustments
page 81 do not appear to	are taken this into account by the filters dedicated to overall system calibration.
change the graphical output.
Lower frequency response	• Low frequencies used in bass management (the subwoofer channel) will not
curves do not seem to have	change for speakers that have been specified as SMALL in the configuration,
been calibrated for SMALL	or do not output these frequencies.
speakers.	• Calibration is performed, but due to your speakers’ low frequency limitations,
	no measurable sound is output for display.

Display

Symptom	Remedy
The display is dark or off.	• Press DIMMER repeatedly to select a different brightness.
After making an adjustment	• Press DIMMER repeatedly to select a different brightness.
the display goes off.

You can’t get DIGITAL to display when using SIGNAL SEL.

•Check the digital connections and make sure that the digital inputs are assigned correctly (see The Input Setup menu on page 40).

•If the multichannel analog inputs are selected, select a different input function.

2 DIGITAL or DTS does not	• These indicators does not light if playback is paused.
light when playing Dolby/DTS	• Check the playback (especially the digital output) settings of the source
software.	component.
When playing Dolby Digital	• Check that the player is connected using a digital connection.
or DTS sources, the receiver’s	• Make sure that the receiver is set to AUTO or DIGITAL (see Choosing the
format indicators do not light. input signal on page 57).
	• Check that the player isn’t set up so that Dolby Digital and DTS sources are
	converted to PCM.
	• Ensure that if there are several audio tracks on the disc, the Dolby Digital or
	DTS is selected.
When playing certain discs,	• The disc may not contain 5.1/6.1 channel material. Check the disc packaging
none of the receiver’s format	for more on what audio tracks are recorded on the disc.
indicators light.
When playing a disc with the	• Make sure that the receiver is set to AUTO or DIGITAL (see Choosing the
listening mode set to Auto	input signal on page 57).
Surround or ALC, 2 PL II or	• If a two channel soundtrack is currently playing (including Dolby Surround

Neo:6 appear on the receiver. encoded), then this is not a malfunction. Check the disc packaging for details about the audio tracks available.

107

En