Perfectone Net Ware GW-200 manual

Page 11

GW-200 User Manual

￿register ttl : The gateway will send a keep-alive registration message

to gatekeeper every “register ttl” seconds. The value range is 10-65535. Default is 60.

￿jitter size : Set buffer size of RTP package. The value range is 0-32.

￿service type: This option is used to accommodate the miscellaneous requirements of the system providers. When gateway is connected to these systems, please select the corresponding service type.

￿￿Common: no special requirements

￿￿Mediaring: use Mediaring prepaid card

￿￿Etalk: use etalk prepaid card. When this is selected, please select “dialnum” from the “Use dialplan” list box and put “00” into “dial number”.

￿￿Auvtech: use Auvtech’s system. When connected with Auvtech’s system, please select “auvtech” from the “nat traversal ” list box, select “account” from the “local type” list box.

￿￿Subcentrex: Use Subcentrex’s system

￿￿Ringtec: Use Ringtec’s system. When this is selected, please select “dialnum” from the “Use dialplan” list box and put Ringtec account into “dial number”.

￿￿Smartcon: Use Smartcon’s system

￿￿Dda: Use Dda’s

system

￿￿Vida: Use Vida’s

system

￿￿Citron: Use Citron’s

system

￿￿Asiasoft: Use Asiasoft’s

system

￿￿Huawei: Use Huawei’s

system

￿￿Asiainfo: Use Asiainfo’s

system

￿￿Lucent: Use Lucent’s

system

11

Image 11
Contents Page Page Breif Introduction and how-to-start information If you are using Dhcp IP addressingIf you are not using Dhcp IP addressing Software HardwareSize Operating requirementsElectric requirements Installation Configure by Web browser Configuration   Network SettingPage Protocol Setting Page System Page Phonesettings Page Beiing 10 Shanghai Audio settings Options are g729 g7231 g711u g711a and gsm Other settingsPage Page GW-200 V1.40 settings Password Telnet ConfigurationSet GW-200 Gateway Telnet Commands ExplanationCommand Function Detail description of GW-200 Telnet commands Command ?Relevant usage None Detailed description Command getDetailed description GW-200 V1.40 settings Detailed description Set iptype Command set Syntax description set keywords valueSet subnetmask Set pppidSet ppppin Set ipSet dns2 Set serviceSet service type Set dnsSet nataddr Set serviceaddrSet serviceid Set nattraversalSet account Set signalportSet natttl Set phonenumberSet jittersize Set registerttlSet rtptos Set rtpportSet dialnumber Set dtmfSet dtmf payload Set dialplanSet innerlinepreifx Set iddprefixSet dddprefix Set innerlineSet fwdnumber Set fwdpoweroffSet ringtype Set digitmapSet agc Set audioframesSet 6.3k Set vadSet codec2 Set passwordSet superpassword Set codec1Relevant Usage load Command exit Set upgradeaddrCommand store Relevant Usage store Command loadRelevant usage ftp Relevant usage None Command writeCommand ping Syntax description ping IP address Ftp command Syntax description ftp valueUsage of the phone Receiving calls Dial out the number from phone book Place a call with Fix IP Address