Perfectone Net Ware GW-200 manual

Page 9

GW-200 User Manual

mask and router IP address of gateway manually.

dhcp: Select this item to enable DHCP mode. With this system, your LAN or router automatically assigns all the required network parameters to any device connected to it when the device log on. GW-200 Gateway is shipped from the factory with DHCP on. So, if you’re LAN or router is configured to use DHCP addressing, the gateway’s LAN parameters will automatically be configured as soon as it is connected to the LAN or router and powered up.

pppoe Those ADSL and Cable Modem users please select this item for it is a protocol especially designed for them. With this system, ADSL ISP automatically assigns all the required IP parameters to any device connected to it when the device log on.

modem If the gateway used with modem, please select this item to get relevant network parameters auto. Then please fill ID and pin into ppp id and ppppin fields.

ppp id: With pppoe or modem selected in iptype drop down list, please enter the user name here.

ppp pin: With pppoe or modem selected in iptype drop down list, please enter the password here.

9

Image 9

Contents Page Page If you are using Dhcp IP addressing If you are not using Dhcp IP addressingBreif Introduction and how-to-start information Software HardwareOperating requirements Electric requirementsSize Installation Configure by Web browser Configuration Network SettingPage Protocol Setting Page System Page Phonesettings Page Beiing 10 Shanghai Audio settings Options are g729 g7231 g711u g711a and gsm Other settingsPage Page GW-200 V1.40 settings Password Telnet ConfigurationCommand Function GW-200 Gateway Telnet Commands ExplanationDetail description of GW-200 Telnet commands Command ? SetCommand get Detailed descriptionRelevant usage None Detailed description GW-200 V1.40 settings Detailed description Set iptype Command set Syntax description set keywords valueSet ppppin Set pppidSet ip Set subnetmaskSet service type Set serviceSet dns Set dns2Set serviceid Set serviceaddrSet nattraversal Set nataddrSet natttl Set signalportSet phonenumber Set accountSet rtptos Set registerttlSet rtpport Set jittersizeSet dtmf payload Set dtmfSet dialplan Set dialnumberSet dddprefix Set iddprefixSet innerline Set innerlinepreifxSet ringtype Set fwdpoweroffSet digitmap Set fwdnumberSet 6.3k Set audioframesSet vad Set agcSet superpassword Set passwordSet codec1 Set codec2Command store Set upgradeaddrRelevant Usage store Command load Relevant Usage load Command exitCommand ping Syntax description ping IP address Relevant usage None Command writeFtp command Syntax description ftp value Relevant usage ftpUsage of the phone Receiving calls Dial out the number from phone book Place a call with Fix IP Address