Perfectone Net Ware GW-200 manual System

Page 12

GW-200 User Manual

￿￿IPN: Use IPN’s system

￿￿Yiyang: Use Yiyang’s

system

￿￿Thinker: Use Thinker’s

system

￿￿Suntek: Use Suntek’s

system

￿service addr, service id: Please put the URI (domain name/IP address) of the server into “service addr”.

If “use service” is checked, please put the URI of gatekeeper into “service addr” .The default service port is 1719. If the gatekeeper has a GKID, please put it into “service id”.

If “use service” is not checked, to make calls through gateway, please put the URI of the gateway into “service addr”. To make IP-to-IP call, please clear this field. In both cases, the default service port is 1720.

￿nat traversal: When the gateway with private IP address need communicate with other IP phones in a different LAN or on Internet, please select an item from dropdown list to set the proxy used by the gateway.

￿￿disable: Select this item when the log in server and gateway in the same LAN, or the log in system supports the gateway working behind the LAN.

￿￿enable: When the system does not support gaeway working behind the LAN, please select this item to search public IP address of the NAT device. With this item selected, “nat addr” field will be activated. Besides, port mapping (port forwarding) needs to be properly set up on NAT device.

￿￿citron: With Citron private protocol used, select this item to fit into the GnuGK system transferring the voice and signal by router.

￿￿auvtech: Select this item with Auvtech private system used.

￿￿vida: Select this item with Vida private system used.

￿￿aivgr: Select this item with aivgr private system used.

￿nat addr: When “nat traversal” is set to “enable”, please put the

12

Image 12
Contents Page Page If you are using Dhcp IP addressing If you are not using Dhcp IP addressingBreif Introduction and how-to-start information Hardware SoftwareOperating requirements Electric requirementsSize Installation Configuration Configure by Web browserNetwork Setting   Page Protocol Setting Page System Page Phonesettings Page Beiing 10 Shanghai Audio settings Other settings Options are g729 g7231 g711u g711a and gsmPage Page Telnet Configuration GW-200 V1.40 settings PasswordGW-200 Gateway Telnet Commands Explanation Command FunctionDetail description of GW-200 Telnet commands Command ? SetCommand get Detailed descriptionRelevant usage None Detailed description GW-200 V1.40 settings Command set Syntax description set keywords value Detailed description Set iptypeSet pppid Set ppppinSet ip Set subnetmaskSet service Set service typeSet dns Set dns2Set serviceaddr Set serviceidSet nattraversal Set nataddrSet signalport Set natttlSet phonenumber Set accountSet registerttl Set rtptosSet rtpport Set jittersizeSet dtmf Set dtmf payloadSet dialplan Set dialnumberSet iddprefix Set dddprefixSet innerline Set innerlinepreifxSet fwdpoweroff Set ringtypeSet digitmap Set fwdnumberSet audioframes Set 6.3kSet vad Set agcSet password Set superpasswordSet codec1 Set codec2Set upgradeaddr Command storeRelevant Usage store Command load Relevant Usage load Command exitRelevant usage None Command write Command ping Syntax description ping IP addressFtp command Syntax description ftp value Relevant usage ftpUsage of the phone Receiving calls Place a call with Fix IP Address Dial out the number from phone book