Perfectone Net Ware GW-200 Set audioframes, Set 6.3k, Set vad, Set agc, Set aec, Set handsetin

Page 34

GW-200 User Manual

without replying.

set audioframes X

Set audio frames in RTP package. X is Arabic numerals between 0 and 7.

set 6.3k X

With G.7231, set PA168X IP phone to use 6.3K rate or not. X is ranged from 0 through 1: 0: use 6.3K rate; 1: use 5.3K rate.

set vad X

Enable/disable VAD. X is ranged from 0 through 1: 0: disable VAD;

1: enable VAD.

set agc X

Enable/disable AGC. X is ranged from 0 through 1: 0: disable AGC;

1: enable AGC.

set aec X

Enable/disable AEC. X is ranged from 0 through 1: 0: disable AEC;

1: disable AEC.

set handsetin X

Set initial volume of handset. X is ranged from 0 through 15.

set speakerin X

Set initial volume of microphone of the base. X is ranged from 0 through 15.

set handsetout X

Image 34

Contents Page Page If you are not using Dhcp IP addressing If you are using Dhcp IP addressingBreif Introduction and how-to-start information Hardware SoftwareElectric requirements Operating requirementsSize Installation Configuration Configure by Web browserNetwork Setting Page Protocol Setting Page System Page Phonesettings Page Beiing 10 Shanghai Audio settings Other settings Options are g729 g7231 g711u g711a and gsmPage Page Telnet Configuration GW-200 V1.40 settings PasswordDetail description of GW-200 Telnet commands Command ? GW-200 Gateway Telnet Commands ExplanationCommand Function SetDetailed description Command getRelevant usage None Detailed description GW-200 V1.40 settings Command set Syntax description set keywords value Detailed description Set iptypeSet ip Set pppidSet ppppin Set subnetmaskSet dns Set serviceSet service type Set dns2Set nattraversal Set serviceaddrSet serviceid Set nataddrSet phonenumber Set signalportSet natttl Set accountSet rtpport Set registerttlSet rtptos Set jittersizeSet dialplan Set dtmfSet dtmf payload Set dialnumberSet innerline Set iddprefixSet dddprefix Set innerlinepreifxSet digitmap Set fwdpoweroffSet ringtype Set fwdnumberSet vad Set audioframesSet 6.3k Set agcSet codec1 Set passwordSet superpassword Set codec2Relevant Usage store Command load Set upgradeaddrCommand store Relevant Usage load Command exitFtp command Syntax description ftp value Relevant usage None Command writeCommand ping Syntax description ping IP address Relevant usage ftpUsage of the phone Receiving calls Place a call with Fix IP Address Dial out the number from phone book