Perfectone Net Ware GW-200 Gateway Telnet Commands Explanation, Command Function, Set, Load

Page 22

GW-200 User Manual

P:\>

If you type super password, then you will see:

Password : ********

P:\>

Above information indicates that gateway is under setting mode, and then you can set the GW-200 gateway by using the telnet commands.

GW-200 Gateway Telnet Commands Explanation

GW-200 gateway Telnet Commands

Command	Function
?	Supply command name and parameters
get	Display basic parameters of the GW-200 gateway
set	Set parameters of the GW-200 gateway
store	Save current settings to designated position
load	Load designated settings to current position
exit	Exit from the setting mode without saving the configuration
write	Exit with saving all configurations and restart GW-200 gateway
ping	Ping other net parameter
ftp	The gateway connects to FTP server and then get the files

Detail description of GW-200 Telnet commands

Command ?

Syntax description: No optional parameter

Usage: Type command name and parameters following P:\> . Be used

as the keyword to supply keyword and parameters of the relevant

commands.

Relevant usage: None

22

Image 22

Contents Page Page If you are not using Dhcp IP addressing If you are using Dhcp IP addressingBreif Introduction and how-to-start information Hardware SoftwareElectric requirements Operating requirementsSize Installation Configuration Configure by Web browserNetwork Setting Page Protocol Setting Page System Page Phonesettings Page Beiing 10 Shanghai Audio settings Other settings Options are g729 g7231 g711u g711a and gsmPage Page Telnet Configuration GW-200 V1.40 settings PasswordDetail description of GW-200 Telnet commands Command ? GW-200 Gateway Telnet Commands ExplanationCommand Function SetDetailed description Command getRelevant usage None Detailed description GW-200 V1.40 settings Command set Syntax description set keywords value Detailed description Set iptypeSet ip Set pppidSet ppppin Set subnetmaskSet dns Set serviceSet service type Set dns2Set nattraversal Set serviceaddrSet serviceid Set nataddrSet phonenumber Set signalportSet natttl Set accountSet rtpport Set registerttlSet rtptos Set jittersizeSet dialplan Set dtmfSet dtmf payload Set dialnumberSet innerline Set iddprefixSet dddprefix Set innerlinepreifxSet digitmap Set fwdpoweroffSet ringtype Set fwdnumberSet vad Set audioframesSet 6.3k Set agcSet codec1 Set passwordSet superpassword Set codec2Relevant Usage store Command load Set upgradeaddrCommand store Relevant Usage load Command exitFtp command Syntax description ftp value Relevant usage None Command writeCommand ping Syntax description ping IP address Relevant usage ftpUsage of the phone Receiving calls Place a call with Fix IP Address Dial out the number from phone book