Olitec RW400SG manual I want to use Netmeeting, what do I need to do?

MAC register, login to the router and click the "Network" menu link on the left of your browser, and then click "MAC Clone" submenu link. On the "MAC Clone" page, if your PC’s MAC address is proper MAC address, click the "Clone MAC Address" button and your PC’s MAC address will fill in the "WAN MAC Address" field. Or else, type the MAC Address into the " WAN MAC Address" field. The format for the MAC Address is XX-XX-XX-XX-XX-XX. Then click the "Save" button. It will take effect after rebooting.

Figure A-3 MAC Clone

3.I want to use Netmeeting, what do I need to do?

1)If you start Netmeeting as a sponsor, you don’t need to do anything with the router.

2)If you start as a responsor, you need configure Virtual Server or DMZ Host.

3)How to configure Virtual Server: Login to the router, click the “Forwarding” menu on the left of your browser, and click " Virtual Servers" submenu. On the "Virtual Server" page, enter “1720” into the blank below the “Service Port”, and your IP address below the IP Address, assuming 192.168.1.169 for an example, remember to “Enable” and “Save”.

Figure A-4 Virtual Server

Note: Your opposite side should call your WAN IP, which is displayed on the “Status” page.

4)How to enable DMZ Host: Login to the router, click the “Forwarding” menu on the left of your browser, and click " DMZ" submenu. On the "DMZ" page, click “Enable” radio and type your IP address into the “DMZ Host IP Address” field, using 192.168.1.169 as an example, remember to click the "Save” button.

-51 -