Olitec RW400SG manual

Page 65

¾Domain Name - A descriptive name for an address or group of addresses on the Internet.

¾DoS (Denial of Service) - A hacker attack designed to prevent your computer or network from operating or communicating.

¾DSL (Digital Subscriber Line) - A technology that allows data to be sent or received over existing traditional phone lines.

¾ISP (Internet Service Provider) - A company that provides access to the Internet.

¾MTU (Maximum Transmission Unit) - The size in bytes of the largest packet that can be transmitted.

¾NAT (Network Address Translation) - NAT technology translates IP addresses of a local area network to a different IP address for the Internet.

¾PPPoE (Point to Point Protocol over Ethernet) - PPPoE is a protocol for connecting remote hosts to the Internet over an always-on connection by simulating a dial-up connection.

¾SSID - A Service Set Identification is a thirty-two character (maximum) alphanumeric key identifying a wireless local area network. For the wireless devices in a network to communicate with each other, all devices must be configured with the same SSID. This is typically the configuration parameter for a wireless PC card. It corresponds to the ESSID in the wireless Access Point and to the wireless network name.

¾WEP (Wired Equivalent Privacy) - A data privacy mechanism based on a 64-bit or 128-bit or 152-bit shared key algorithm, as described in the IEEE 802.11 standard.

¾Wi-Fi - A trade name for the 802.11b wireless networking standard, given by the Wireless Ethernet Compatibility Alliance (WECA, see http://www.wi-fi.net), an industry standards group promoting interoperability among 802.11b devices.

¾WLAN (Wireless Local Area Network) - A group of computers and associated devices communicate with each other wirelessly, which network serving users are limited in a local area.

- 61 -

Image 65
Contents Users Guide RW400SG Router OLITECPage 5.6.1 DHCP Settings Appendix A FAQ 5.11.3 Factory DefaultsAppendix B Configuring the PCs Appendix C Specifications2.1 Overview of the Router 2.2 FeaturesChapter 2 Introduction 2.3.1 The Front Panel 2.3 Panel Layout2.3.2 The Rear Panel 3.2 Installation Environment Requirements Chapter 3 Connecting the Router3.3 Connecting the Router 3.1 System Requirements(XDSL 、Cable 、Ethernet ) Switch/HubTo LAN To WAN4.1 TCP/IP configuration Chapter 4 Quick Installation Guide4.2 Quick Installation Guide Figure 4-5 Quick Setup Figure 4-4 Login WindowsFigure 4-6 Choose WAN Connection Type If you choose PPPoE, you will see this page shown in figureFigure 4-7 Quick Setup - PPPoE In this page, you can configure the following wireless parameters 5.1 login Chapter 5 Configuring the Router2. Wireless Radio, SSID, Channel, Mode, Wireless MAC address and IP address5.4 Network 5.3 Quick SetupPlease refer to Section 4.2 Quick Installation Guide Figure 5-1 Router Status5.4.2 WAN 5.4.1 LANFigure 5-4 WAN - Dynamic IP Figure 5-4a WAN - 802.1X + Dynamic IP Click Logout button to end 802.1x authenticationFigure 5-5 WAN - Static IP You should type the following parameters into the spaces providedClick Logout to end 802.1x authentication Click Login to start 802.1x authenticationFigure 5-5a WAN - 802.1X + Static IP Figure 5-6 WAN - PPPoEFigure 5-7 PPPoE Advanced Settings 5.4.3 MAC Clone 5.5.1 Wireless Settings 5.5 Wireless¾ Mode - Select the desired wireless mode. The options are Encryptions 5.5.2 MAC Filtering Figure 5-12 Add or Modify Wireless MAC Address Filtering entry 5.5.3 Wireless Statistics 5.6 DHCP 5.6.1 DHCP Settings5.6.2 DHCP Clients List To Reserve IP addresses 5.6.3 Address ReservationTo modify A Reserved IP address To delete all Reserved IP addresses5.7.1 Virtual Servers 5.7 ForwardingTo delete a service entry To setup a virtual server entryTo delete all service entries To modify a virtual server entryFigure 5-20 Port Triggering Once configured, operation is as follows Deleting an existing rule Modifying an existing ruleTo delete all rules 5.7.3 DMZ5.7.4 UPnP 5.8.1 Firewall 5.8 Security5.8.2 IP Address Filtering 5.8.3 Domain Filtering Figure 5-27 Domain Filtering Click the Enabled All button to make all entries enabledFigure 5-28 Add or Modify a Domain Filtering entry To add or modify a Domain Filtering entry, follow these instructions5.8.4 MAC Filtering 5.8.5 Remote Management 5.8.6 Advanced Security Click the Save button to save the settings To add static routing entries 5.9 Static RoutingTo modify an existing entry 1. Modify the entry’s Destination IP Address, Subnet Mask and GatewayTo delete all the entries 5.10 DDNS5.10.1 Dyndns.org DDNS 5.10.2 Oray.net DDNS5.10.3 Comexe.cn DDNS 5.11 System Tools 5.11.2 Firmware 5.11.1 Time5.11.4 Reboot 5.11.3 Factory Defaults5.11.5 Password Statistics Table 5.11.6 Log5.11.7 Statistics The total amount of packets received and transmitted by the router Click the Refresh button to refresh immediately1. How do I configure the router to access Internet by ADSL users? Appendix A FAQ3. I want to use Netmeeting, what do I need to do? 4. I want to build a WEB Server on the LAN, what should I do? 5. The wireless stations cannot connect to the router 2. Configure TCP/IP for your computer Appendix B Configuring the PCs1. Install TCP/IP component Assigned by DHCP Sever Figure B-5 Gateway tab Setting IP address manuallyFigure B-6 DNS Configuration tab Figure B-8 Gateway tab Figure B-7 IP Address tabclick Add button. Shown below Figure B-9 DNS Configuration tab General Appendix C SpecificationsAppendix D Glossary ¾ Domain Name - A descriptive name for an address or group of addresses on the Internet