PS Audio 1500 MKII manual Output ‘Frequency Setting

Page 13

®

Installation & Operating Instructions

Owner’s Reference PowerPack 1500 MKII

2.6.4.2Output

‘Frequency Setting

• Press and hold the main off switch

“” to select the output voltage setting mode.

•Press and hold the main on switch “I” for more than 3 seconds to select differ- ent output voltage settings.

All Level LEDs off

Output = 115V (230V)

6th Level LED on

Output = 110V (220V)

5th Level LED on

Output = 120V (240V)

5th, 6th Level LED on Output = 127V (208V)

4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 service@psaudio.com www.psaudio.com	Getting Started 13

©2009 PS Audio International Inc. All rights reserved.

Image 13

Contents Introduction Owner’s ReferenceTable Of Contents Introduction Important Safety InstructionsSystem Descriptions Features Box should include the following Unpacking & Inspection OverviewGetting Started 5V Rear Panel Charge the Battery InstallationVentilation Connect to ACConnect the Load Connect to PowerPlayOn Battery Mode AC ModeOperation and Functionality Test To conduct a simulation-test Manual Simulation of Power Outage for the UPSInstallation & Operating Instructions Setting Parameters Output ‘Frequency Setting Output ‘Frequency Setting Installation & Operating Instructions AVR Boost Range Setting Energy Saving mode Audible / Visual Indicators Operating Status Visual IndicatorsLED1 LED2 LED3 LED4 LED5 LED6 Abnormal Status Indicators Screws Interface with PowerPlay Interface with PowerPlayWarranty WarrantyConditions Remedy Miscellaneous Outside the US Service Service in NorthIf you require AmericaIf you have problems Voltage changes ServiceYour serial Number Your purchase informationTroubleshooting TroubleshootingTroubleshooting Troubleshooting Specifications subject to change without prior notice Specifications Specifications