®
Installation & Operating Instructions
|
|
| Owner’s Reference PowerPack 1500 MKII |
|
|
|
|
2.3 Installation | Before installation, please read and understand the following instructions: | ||
| Placement | ||
| The UPS must be installed in a protected environment away from | ||
| appliances such as a radiator or heat register. Do not install this product where | ||
| excessive moisture is present. | ||
|
|
|
|
|
|
|
|
|
|
|
|
Ventilation
The location should provide adequate air flow around the UPS with one inch minimum clearance on all sides for proper ventilation.
Charge the Battery
Your new UPS may be used immediately upon receipt. However charge loss may occur during shipping and storage. So charging the battery for at least 8 hours is recommended to insure that the battery is fully charged.
To recharge the battery, simply leave the unit plugged into an AC outlet. (This UPS will recharge in both the On and the Off status.)
Connect to AC
Make sure that the voltage and frequency are correct. Plug the UPS into a 2 pole, 3 wire grounding receptacle (wall outlet). Make sure the wall outlet branch is protected. Avoid using extension cords if at all possible. If used, make sure the extension cord is rated for 15 Amps.
For 220/230/240V versions: Swap the input power cord of the equipment to the inlet of UPS. Use the power cord supplied with the UPS to connect from the outlet of the UPS to your equipment.
Determining the Load:
1. Make a list of all equipment that requires protection.
4826 Sterling Drive, Boulder, CO 80301 |
|
PH: 720.406.8946 service@psaudio.com www.psaudio.com | Getting Started 7 |
©2009 PS Audio International Inc. All rights reserved.