PS Audio 1500 MKII manual AVR Boost Range Setting

Page 15

®

Installation & Operating Instructions

Owner’s Reference PowerPack 1500 MKII

2.6.4.4AVR Boost

Range Setting

AVR Boost Range sets the range at which the UPS will switch over to battery when the utility presents an undervoltage situation.

•Press and hold the main off switch “” to select the AVR Boost Range Setting mode.

•Press and hold the main on switch “I” for more than 3 seconds to select differ- ent AVR boost ranges.

AVR Boost Range mode

All Level LEDs off AVR Boost = -25%

6th Level LED on

AVR Boost = -30%

5th Level LED on

AVR Boost = -20%

4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 service@psaudio.com www.psaudio.com	Getting Started 15

©2009 PS Audio International Inc. All rights reserved.

Image 15

Contents Introduction Owner’s ReferenceTable Of Contents Introduction Important Safety InstructionsSystem Descriptions Features Unpacking & Inspection Overview Box should include the followingGetting Started 5V Rear Panel Connect to AC InstallationCharge the Battery VentilationConnect the Load Connect to PowerPlayAC Mode On Battery ModeOperation and Functionality Test To conduct a simulation-test Manual Simulation of Power Outage for the UPSInstallation & Operating Instructions Setting Parameters Output ‘Frequency Setting Output ‘Frequency Setting Installation & Operating Instructions AVR Boost Range Setting Energy Saving mode Audible / Visual Indicators Operating Status Visual IndicatorsLED1 LED2 LED3 LED4 LED5 LED6 Abnormal Status Indicators Screws Interface with PowerPlay Interface with PowerPlayWarranty WarrantyConditions Remedy Miscellaneous Outside the US America Service in NorthService If you requireNumber Your purchase information ServiceIf you have problems Voltage changes Your serialTroubleshooting TroubleshootingTroubleshooting Troubleshooting Specifications subject to change without prior notice Specifications Specifications