PS Audio 1500 MKII manual Interface with PowerPlay

®

Interface with PowerPlay

Owner’s Reference PowerPack 1500 MKII

3.Interface with PowerPlay

When connected with a PS Audio PowerPlay or Audio Video Power Center, the UPS communications cable provides critical information to the power condi- tioner. In order to enable PS Audio’s revolutionary Intelligent UPS Management Control and Configuration connect the RS-232 (DB9) end of the included com- munications cable into the PowerPack. Then connect the 3-Pin connector to the UPS port of the PS Audio power conditioner. Finally plug the power cable for the power conditioner into one of the outputs of the PowerPack.

Note: The Intelligent Management Control and Configuration is only available for devices powered from the PS Audio power conditioner. When a PS Audio Power Conditioner is connected it is not recommended to power any other devices directly from the PowerPack.

PowerPlay

Connect Power play UPS to Interface connection on the UPS

PowerPack 1500 MKII

		EXT.BATTERY
	OUT
				SNMP/HTTP SLOT
			AC INPUT	SITE
		NET		WIRE FAULT
		WORK
	IN	OUT	IN
UPS OUTPUT	FAX/MODEM		INTERFACE	AC FUSE

115V Rear Panel

4826 Sterling Drive, Boulder, CO 80301

PH: 720.406.8946 service@psaudio.com www.psaudio.com Getting Started 21

©2009 PS Audio International Inc. All rights reserved.