PS Audio 1500 MKII manual Installation & Operating Instructions

®

Installation & Operating Instructions

Owner’s Reference PowerPack 1500 MKII

2.6Operating Parameter Setting

2.6.1Configuration

Mode

2.6.2Display and

Control Switch

2.6.3End of

Configuration mode

Restore electrical power to connected equipment by re-plugging the UPS power cord into a wall outlet

Press and hold both the main on switch “I” and the main off switch “” on the front panel for more than 3 seconds while the UPS is in the off status. The UPS will now enter parameter configuration mode.

Level Indicator

Status Indicator

•When the UPS enters into the configuration mode, the turn on of six different status indicator LEDs represent different parameter being programmed.

•Different parameter can be selected by pressing and holding the main off switch “” for more than 3 seconds.

•Different settings can be selected by pressing and holding the main on switch

“I” for more than 3 seconds.

• To Exit the configuration mode:

Press and hold both the main on switch “I” and off switch “” for more than 3 seconds.

4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 service@psaudio.com www.psaudio.com	Getting Started 11

©2009 PS Audio International Inc. All rights reserved.