PS Audio 1500 MKII manual Unpacking & Inspection Overview, Box should include the following

Page 5

®

Installation & Operating Instructions

Owner’s Reference PowerPack 1500 MKII

2.1Unpacking & Inspection

2.2Overview

Examine the packing carton for damage upon receipt. Once the UPS has been removed from its shipping container, everything inside the package should be inspected for damage that may have occurred while in transit. Notify the carrier immediately if any damage is observed.

The box should include the following

UPS and Input Power Cord

User Manual

PowerPlay and Audio Video Power Center Communications Cable

Retain the packing for future use or disposal of property.

Item

Panel Indicator

Description

1

Main On Switch

Turn on UPS, Silence and Self-Test

 

(Silence/Test) “ ”

 

 

 

 

 

 

2

Main Switch Off “

 

Turn off UPS

 

 

 

 

 

 

 

3

Capacity Indicator

LED bar shows load size and battery capacity

 

 

 

 

 

4

AC Buck Mode Indicator

Continuous Amber LED display AC buck

 

 

 

 

 

5

AC Normal Indicator

Continuous Green LED display AC normal

 

 

 

 

 

6

AC Boost Mode Indicator

Continuous Amber LED display AC boost

 

 

 

 

 

7

Backup Mode Indicator

Continuous Green LED displays backup mode

 

 

 

 

 

8

Battery Replace Indicator

Continuous Red LED displays battery failure

9

UPS Warning / Fault Indicator

 

 

 

 

 

 

10

RS232 Communication

Displays Flashing/Continuous Red LED Trans-

 

Interface

mits UPS status and receives control

 

 

 

 

 

11

Site Wire Fault Indicator

Commands from the computer system. The

 

 

 

 

LED will illuminate upon hot and neutral polarity

 

 

 

 

reversal, or a bad ground connection.

 

 

 

 

 

4826 Sterling Drive, Boulder, CO 80301

 

PH: 720.406.8946 service@psaudio.com www.psaudio.com

Getting Started 5

©2009 PS Audio International Inc. All rights reserved.

Image 5
Contents Introduction Owner’s ReferenceTable Of Contents Introduction Important Safety InstructionsSystem Descriptions Features Getting Started Unpacking & Inspection OverviewBox should include the following 5V Rear Panel Charge the Battery InstallationVentilation Connect to ACConnect the Load Connect to PowerPlayOperation and Functionality Test AC ModeOn Battery Mode To conduct a simulation-test Manual Simulation of Power Outage for the UPSInstallation & Operating Instructions Setting Parameters Output ‘Frequency Setting Output ‘Frequency Setting Installation & Operating Instructions AVR Boost Range Setting Energy Saving mode Audible / Visual Indicators Operating Status Visual IndicatorsLED1 LED2 LED3 LED4 LED5 LED6 Abnormal Status Indicators Screws Interface with PowerPlay Interface with PowerPlayConditions Remedy WarrantyWarranty Miscellaneous Outside the US Service Service in NorthIf you require AmericaIf you have problems Voltage changes ServiceYour serial Number Your purchase informationTroubleshooting TroubleshootingTroubleshooting Troubleshooting Specifications subject to change without prior notice Specifications Specifications