The Eltron Company P310 manual Rear Plate Removals

CHAPTER 5

5.2.11 Rear Plate Removal

Access to the Daughter Board and the associated motor and sensor connectors, and their related component replacements, requires removal of the Rear Plate. Of these, only the Card Feed Motor Connector is accessible with the Rear Plate in place. Refer to Figure

5-15, and proceed as follows:

Step 1. Remove the Rear Case member (see Section 5.2.1).

Step 2. Unplug the connectors attached to the circuit boards (see Section 5.2.10).

Step 3. Remove the three screws holding the Rear Plate, followed by the plate itself. Note that the figure shows the Rear Plate without the circuit boards, which can remain attached.

Step 4. Remove the Cam Follower Rod and Flywheel when required for access to underlying components. Note rotations for Cam Follower Rod attachment points.

Figure 5-15. Rear Plate Removals.

980264-001 Rev. B 5-17