Configuration of the cable terminal block:
Temperature sensor |
|
measuring signal: | Temp |
Solar radiation |
|
measuring signal: | Solar |
Positive supply, 5V: | V+ |
Supply, GND: | V- |
Using a small screwdriver, press the orange
terminal. The terminal will open. | EN |
Insert the cable stripped to a minimum of |
|
11 mm into the respective terminal hole. |
|
Loosen the screwdriver. The cable is fixed |
|
in the connection. |
|
Once again, check that the cable connec- tion is firmly located.
Seal the unrequired cable glands by placing a spare piece of cable in the gland hole and tightening the screw clamp.
103