Settings You Can Change with the User Tools
Interface Settings/Parallel Interface
❖Parallel Timing
Specifies the timing setting for the parallel interface. Under normal circum- stances, you will not need to change this setting.
Note
❒Default: ACK outside
❖Parallel Communication Speed
Specifies the communication speed for the parallel interface. If the communi- cation speed is set too fast, data transfers may not flow smoothly. If this oc- curs, change the setting to “Standard”.
Note
❒Default: High speed
❖Selection Signal Status
Specifies the level for the select signal setting of the parallel interface.
Note
❒Default: High
❖Input Prime
Specifies whether the prime signal is active or inactive when an input prime signal is sent. Under normal circumstances, you will not need to change this setting.
Note
❒Default: Invalid
❖Bidirectional Communication
Specifies the printer's response mode etc., for status request when using the parallel interface. If you experience problems when using other manufactur- ers printers, set this to “Off”. However, if this is set to “Off”, asynchronous functions will not work.
Note
❒Default: Yes
❖Signal Control
Specifies the error processing settings for when an error occurs when printing from a computer or sending faxes. Under normal circumstances, you will not need to change this setting.
Note
❒Default: Job acceptance priority
3
45