Programming Channels
Before you can scan, you must program the channels within a
bank. You can store one frequency per channel, up to 200 channels.
Note: If appears on the display (keypad Locked), unlock the keypad by pressing and holding (LOCK)until
disappears and you hear two beeps.
There are two ways to program a channel:
. Manually select a channel and frequency, using the numeric keypad.
. Search a band to find an active frequency, and then directly store it into a selected channel. (See the Search section, page 21).
Programming By Manual Entry
1. Select a desired frequency.
Example: Program 125.2500 MHz into Channel 18.
2.Make sure the scanner is not scanning or searching.
3.Otherwise, press @ to stop SCANNING or deactivate
SEARCH MODE.
4.Press CDCD~to go to Channel 18.
5.
Enter the frequency number using the numeric keypad. (Be sure to include the decimal point.) As soon as you enter the first digit of the frequency, the channel number begins to blink.
CD CD CD CV CD CD.
BANK 2
:18/:125.25
/ I "
HOLD
If you make a mistake and want to clear the entry, press
CVtwice and
14