Uniden UBC220XLT manual While Scanning, press @, Scan Mode. PR~ears On the display. While

Page 10

G.Indicates the keypad is locked.

H.Priority Channel Indicator - P appears when the scanner stops on a Priority Channel.

2.Press @ to start scanning all programmed channels that are not locked out. (SCAN moves across the display during scanning.)

3.ln SCAN Mode, press ~ to stop scanning. (HOLD appears on the display.) After you stop the scanner, press @ again to resume scanning.

4.Press ~u;mj\J1HTtoagaintoturn themanuallyturndisplay backlightthe lightOFFON for 15. seconds.

5.Use 0 to enter the decimal point when programming a

frequency into a channel. If you make an entry error, press C!) twice to erase the entry, and start over again.

6.There are 7 Preprogrammed weather channels. Press @ to find the active weather channel in

your area. WX appears on the display in Weather Mode.

7.Use @ to set the limits of a range of frequencies for Search Mode. When Search is stopped, or in SCAN

HOLD Mode, use.. to go down in frequency.

8. While Scanning, press @

to enter the PRIORITY

 

SCAN Mode. (PR~ears

on the display.) While

-

Searching, press ~ (TURBO) to toggle between 100 steps and 300 steps per second. (When in TURBO

SEARCH Mode, SRCH flashes on the display.)

9.Press(DELAY)to turn ON or OFF the automatic 2-seconddelay during scanning or searching for active frequencies. (In Delay Mode, DLY appears on the display.) In this mode, when the scanner monitors an active frequency, searching or scanning will not resume until transmission stops for 2 seconds.

10.Press and hold(LOCK). rl appears on the display and you hear two beeps. This disables the keypad and

preventskeypad, pressany accidentaland hold (eyLOCK)ntries. rl . disappearsTo enable fromthe the display and you hear two beeps.

8

Image 10
Contents UBC 220XL T Precautions Before you use this scanner, please read and observeTable of Contents About Your New UBC 220XLT Types of Communication BeltClip UnpackingFeature Highlights Priority Channels You can assign one PriorityVolume Control Controls and IndicatorsControl PAl Indicates Priority Scan Mode Indicates Scan ModeWhen in Turbo Search Mode Weather Scan ModeWhile Scanning, press @ Scan Mode. PR~ears On the display. While~ars Key Bank Channel D1 1 CD 2 21Air Band Setu p Using the Earphone Installing the Belt Clip~ ~ Insert the 2 screws into the corresponding holes Operation Overview ~ SC RN Bank 1 2 3 4 5 6 7 8 918/125.25 To program another channel, repeat the above procedures Deleting a Stored FrequencyLook at the lower left corner of the display. If SCNis not ScanningPriority Scan To activate Priority Scan, press @. The PRI indicator willPress @ Ch L DC Due Weather Channel Scanning DIc1A indicator disappears from the display Press DAT~to activate the Data Skip feature. The DIc1JSearching ~iY~BD6.DDDD Care and Maintenance Replacing the Battery PackLocation Birdies Proper Care of Your ScannerTrou bleshooti n9 Optional Accessories Replacement Parts Technical Specifications Channels BanksUnidl!n@