Location

6.Insert the Battery Pack into the scanner

so the label side is

showing. Make sure it is seated within the

case before replacing the Battery Cover.

7.Replace the Battery Cover by putting the two tabs in the corresponding opening and sliding it upward until it locks in place.

@ l@ 0 @J @

(@@I

@~@

Location
.	Ifstronginterferenceorelectricalnoiseisreceived,	I
	relocate the scanner or its antenna away from the	I
	relocate the scanner or its antenna away from the
	source of the noise. A higher elevation, if possible, may
.	provide better reception.
.	Donot use the scanner inhigh-moistureenvironments
	such as the kitchen or bathroom.
.	Avoid placing the unit in direct sunlight or near heating
	elements or vents.
Cleaning
.	Disconnect the AC Adaptor/Charger and/ remove the
	battery from the unit before cleaning.
.	Clean the outside of the scanner with a mild detergent.
.	To prevent scratches, do not use abrasive cleaners or
	solvents. Be careful not to rub the LCD window.
.	Do not use excessive amounts of water.

Repairs

Do not attempt any repair. The scanner contains no serviceable parts. Contact the Uniden Technical Service Division or take it to a qualified repair technician.

Ifstronginterferenceorelectricalnoiseisreceived,

Donot use the scanner inhigh-moistureenvironments

Cleaning

Repairs