Uniden UBC220XLT manual Searching, Press DAT~to activate the Data Skip feature. The DIc1J

Page 22

Searching

The UBC 220XL T can search bands you specify to find desired frequencies if you do not have a Frequency Directory handy, or if new stations have been added since the Di rectory was published.

1.Press ~ to stop scanning.

2.Use the numeric keypad to enter the lowest frequency of the range you want to search.

3.Press (LlMri).

4.Enter the highest frequency of the range you want to search.

5.Press ~IMri).

6.Press ISRCHI.

During a Search, press @ to activate TURBO SEARCH.This increases the Search Speed to 300

steps per second in those bands that have 5 KHz steps. (See the table on page 3 for the Band Chart.) When

you activate TURBOSEARCH,the SRCH indicator

flashes. Press @again to deactivate TURBO SEARCH.

7.Press (HOLD)at any time to stop the search on a frequency. Press ISRCHIagain to resume searching.

8.When Search is stopped, you can press A or ~ to move up or down 1 frequency step. (See the table on page 3 for the step size for each Band.)

Using DATA Skip.

A scanner will normally stop on any transmission it receives. This means the UBC 22OXLT will stop on Data signals and unmodulated transmissions. You can skip these frequencies during Search.

Press (DAT~to activate the DATA Skip feature. The DIc1"J(

indicator appears on the display. The scanner may pause momentarily at an unwanted signal, but will resume searching in 2 or 3 seconds. To deactivate DATA Skip, press (DAT~.

The DIc1"A indicator disappears from the display.

Note: DATA Skip does not function on the AIR Band.

The DIc1"J( indicator will not appear on the display even if this feature is activated.

20

,-

Page 21 Page 23
Image 22
Page 21 Page 23
Contents UBC 220XL T Precautions Before you use this scanner, please read and observeTable of Contents About Your New UBC 220XLT Types of Communication BeltClip UnpackingFeature Highlights Priority Channels You can assign one PriorityVolume Control Controls and IndicatorsControl PAl Indicates Priority Scan Mode Indicates Scan ModeWhen in Turbo Search Mode Weather Scan ModeWhile Scanning, press @ Scan Mode. PR~ears On the display. While~ars Key Bank Channel D1 1 CD 2 21Air Band Setu p Using the Earphone Installing the Belt Clip~ ~ Insert the 2 screws into the corresponding holes Operation Overview ~ SC RN Bank 1 2 3 4 5 6 7 8 918/125.25 To program another channel, repeat the above procedures Deleting a Stored FrequencyLook at the lower left corner of the display. If SCNis not ScanningPriority Scan To activate Priority Scan, press @. The PRI indicator willPress @ Ch L DC Due Weather Channel Scanning DIc1A indicator disappears from the display Press DAT~to activate the Data Skip feature. The DIc1JSearching ~iY~BD6.DDDD Care and Maintenance Replacing the Battery PackLocation Birdies Proper Care of Your ScannerTrou bleshooti n9 Optional Accessories Replacement Parts Technical Specifications Channels BanksUnidl!n@
Top Page Image Contents