Scanning
1. | After programming frequencies, simply press SCAN to begin |
| ||||
C 001 | ||||||
| scanning. During scanning, when you rotate the VFO, you can | |||||
| ↑ | or | ↓ | ) you want to scan. | SCAN | |
| select the direction ( |
| Bank 1234567890 | |||
2. | The bank indicators selected for scanning appear on the | |||||
| ||||||
| display, and the bank being currently monitored flashes. You |
| ||||
|
| |||||
can deselect banks from active scanning by entering their number on your keypad. The indicator for each deselected bank disappears, and the bank’s channels are not scanned.
Note: One bank must always be active. You cannot deactivate all ten banks at the same time. If you try to disappear all the banks, the first bank is automatically selected.
To restore a bank to active scanning, enter the bank’s number on your keypad. The bank’s indicator will display again.
3.During normal scanning the scanner skips unprogrammed or locked out channels.
4.When a transmission is received, the scanner stops on that channel. When the transmission ends, scanning resumes automatically.
Scan Hold Feature
SCAN
CHANNELS 1 2 3 4 5 6 7 8 9 10
Frequency | Frequency |
Locked Out | not entered |
(L/O) |
|
If you want to stop on a channel during scanning, press ▲/HOLD.
Note: When you press and hold SCAN for 2 seconds, the scanner will move to the smallest empty channel.
If you want to resume scanning, press RSM.
To directly access a specific channel:
There are several ways to access a specific channel quickly.
1.Press ▲/HOLD.
2.Using the keypad, enter the channel number.
3.Press ▲/HOLD again.
Another method is as follows:
1.Press ▲/HOLD.
2.When the VFO setting is in the channel mode, rotate the VFO until the desired channel is displayed. The scanner will automatically go to Hold mode.
C 001
1300.0000 NFM
25cm Amateur 1
UNIDEN Group A
C1000
0000.0000
Bank 10
30