Uniden BC785D manual Problem Suggestion

Problem		Suggestion
APCO P25 CARD	1.	Check to see if the P-25 card is properly installed.
NOT INSTALLED
appear when the scanner
is turned on.
Neither APCO P25	1.	Check to see if the APCO CARD Mode is ENABLE
CARD INSTALLED		or DISABLE in the Menu mode (See page 68-69).
nor APCO P25 CARD
NOT INSTALLED
appear when the scanner
is turned on.
Scratchy or robotic sound	1.	Move to a location where the signal strength is
is heard during		strong.
communications.

Digital communication is not heard.

1.Verify the accuracy of the frequencies of the P-25 system you are trying to monitor.

2.You might be in a dead-spot for the P-25 system you are trying to monitor. Check other locations in the area.

DATA sound is heard at	1.	APCO project 25 systems can send data before
the beginning of digital		voice communication.
communications.	2.	Data sound can be heard when signal strength is
		weak.
Robotic sound is heard.	1.	Check to see if the ENC message appears on the
		display.
		The scanner doesn’t monitor encrypted voice
		communications.
CARD ERROR appears	1.	Re-install the P-25 Card.
every 10 seconds while
you are using P-25 card.

If you still cannot get satisfactory results while using your scanner or if you want additional information, please call or write the Uniden Parts and Service Division. The address and phone number is listed in the warranty at the end of this manual. If you would like immediate assistance, please call Customer Service at (800)297-1023.

If you have internet access, you can visit scanner.uniden.com for additional information.

80